WS 11

Transmitter Receiver type Wireless Set no. 11.

Australian version.

 

d003

This is my army transmitter-receiver WS no. 11 Australian in working condition on 7 Mhz..

It was manufactured by A.W.A. Amalgamated Wireless Australasia.

 

ws11a

A close look at the front.  The frequency control and the HF powerindicator meter.

 

WS11007

The chassis above with in the midle of the picture, the 807 poweramplifier tube, also the PA coil.

 

WS11008

The under side of the chassis.

 

WSNo11psuDynoHP

The transmitter dynamotor supply. This is activated when the transmitter is working on high output level. It supplies the extra high voltage of 350 volts to the poweramplifier tube 807 for increasing the ouput power.

 

WSNo11psuDynoLP

The low power dynamotor supply unit. It is activated when the receiver is working and also supplying HT voltage of 220 volts to the poweramplifier on low output selection.

 

ws11016

Both the powersupplies

WS11Austr30CWTtruck

The wireless Set no. 11 australian in a truck no..  1. This is a original waretime picture.

ws11d

At last the original schematic paper of the WS 11. This paper was also put to the undercoverplate of the chassis.

066142

Wireless Sets no 11 under test,  in a service division of the Australian army.

WS 101

Wireless Set no 101 Australian transmitter/receiver.

The set has been used in WW2 by the Australian Army. The manufacturer is A.W.A. Amalgamated Wireless Australasia, a Australian manufacturer.

 

The whole set is in excellent condition. Also the inside is excellent.

Just a museum piece.

WS101gerestaureerd001

WS101gerestaureerd002

WS101gerestaureerd003

WS101gerestaureerd004

WS101gerestaureerd005

Below the pictures of the inside of the WS 101.

As you can see, like new. But still a wartime transceiver.

The pictures below, shows the beautiful inside of the transceiver.

WSNo101ray4

WSNo101ray2

WSNo101ray3

020369

The Wireless set no 101 Australian at the Australian Army.